Shop

TXS0108E 8WAY 3.3-5V BIDIRECTIONAL

In stock

Each level converter has the capability of converting 8 pins on the high side to 8 pins on the low side. The level converter provides the serial interface compatible with UART/IIC/SPI port is very easy to use.

This 8-bit non-inverting translator uses two separate configurable power-supply rails. The A port tracks the VCCA pin supply voltage. The VCCA pin accepts any supply voltage between 1.2 V and 3.6 V. The B port tracks the VCCB pin supply voltage.

The VCCB pin accepts any supply voltage between 1.65 V and 5.5 V. Two input supply pins allow for low Voltage bidirectional translation between any of the 1.2 V, 1.8 V, 2.5 V, 3.3 V, and 5 V voltage nodes.

Add To Quote

TYPE C TO DIP CONVERTER

In stock

  • VCC Positive pole of power supply
  • SBU1 Sideband usage
  • SBU2 Sideband usage
  • DP1 USB 2.0 differential signal, position 1, positive
  • DP2 USB 2.0 differential signal, position 2, positive
  • CC1 Configure channels for identification and control
  • CC2 Configure channels for identification and control
  • DN1 USB 2.0 differential signal, position 1, negative
  • DN2 USB 2.0 differential signal, position 2, negative
  • GND Negative pole of power supply
Add To Quote

UBEC-5V/7A

In stock

Features:

  1. Suitable for: RC AirPlane Multirotor helicopter
  2. Ideal for high power application requiring currents up to 7A.
  3. Small size UBEC
  4. Easy to use.
Add To Quote

ULN2003 DRIVER BOARD FOR STEPPER MOTOR GREEN

In stock

This is ULN2003 Driver Module Stepper Motor Driver Board for driving and controlling stepper motors.

ULN2003 Stepper Motor Driver Board uses the ULN2003 DARLINGTON ARRAYS to drive the 4-phase 5-wire stepper motor (5v-12v).

Add To Quote

Ultra Torque Quarter Scale 60kgcm Metal Gear Servo Motor

In stock

The Ultra Torque Quarter Scale 60kgcm Metal Gear Servo Motor is the best choice if you need SSG metal geared servo motors. It is waterproof and provides an excellent performance for airplane, helicopter, BAJA cars, RC-cars, and many RC models. It provides 58kg/cm at 6V, and 65kgcm at 7.4V. The product configure table is provided in the attachments. Please refer to it to get more information regd. the dimensions of the product.

Add To Quote

UNI-T 890D+

In stock

USES:

1. Electrical switchboards 2. HVAC systems 3. Electrical circuit faults detection 4. Installation or maintenance of electronics/factory equipment 5. Electronics component development, circuit board design 6. Users who need to distinguish between neutral/live wire frequently

Add To Quote

UNI-T UT33D MULTIMETER

In stock

  1. Clear LCD display
  2. Equipped with comfortable protective cover, test lead hanging slot
  3. 2m drop proof with a precision protection
  4. Auto power off
  5. Auto backlight off
  6. Loud buzzer
  7. Ergonomically designed rotary switch
Add To Quote

UNO-PROTOSHIELD

In stock

  1. It has a nice standard 0.1″x0.1″ prototyping grid with big pads
  2. Comes with Stacking headers and plain header, choose whichever you want when soldering together
  3. An IC pattern for adding DIP ICs up to 20 pins
  4. Power rails down the middle and sides
  5. A reset button and an extra general use button
  6. Two 3mm general use LEDs, red and green, as well as 2 matching resistors
  7. A pass-thru ICSP stacking header so you can stack any kind of shield on top, and/or use an AVR programmer
  8. A surface-mount chip area for up to 14 SOIC size parts
  9. Compatible with tiny breadboards
  10. Every pin is brought out!
  11. Gold plated pads
  12. 2 x 0.1uF capacitors on either side for extra power stability
Add To Quote

Unsoldered Lora 915MHz Shield for TTGO T-SIM7000G Module

In stock

The 915 MHz antenna needs to be connected with the IPEX interface (If the antenna is not connected, the signal may be almost. When the battery is full, the blue LED will stop working. When using, pay attention to “+” and “-” of the battery, otherwise, it will be damaged. With the IO port touchscreen touch signal input, you need to add the 100nF pull-down capacitor to this pin.

Add To Quote

USB ASP AVR Programming Device for ATMEL Processors

In stock

The USB ASP AVR Programming Device for ATMEL processors is a USB in-circuit programmer for Atmel AVR controllers. This  ATMEL Processors simply consists of an ATMega88 or an ATMega8 and a couple of passive components. The programmer uses a firmware-only USB driver; no special USB controller is needed.

Add To Quote

USB CP2102 To TTL RS232 USB TTL To RS485 Mutual Convert 6 In 1 Convert Module

In stock

Win8,win7,winxp,win2k,wince,linux,mac,system, 32-bit, 64-bit system, driver support.

Add To Quote

USB DC BOOST

In stock

You can supply it with single-cell LiPO or an AA size batter or others. Two AA batteries can output a current of 500 ~ 600MA, a single AA battery power supply can output 200ma current supply, great for mobile phones camera, single-chip, digital products supply.

Add To Quote

USB DC BOOST MODULE WITH CHARGER TYPE C

In stock

Type-C USB 5V 1A Step-Up Boost Converter Power Bank Charging Module with Charging Protection is a great Step-up Module with 5V input, and output 5V for many digital devices, so this is really a great module for designing a portable charger.

 

Add To Quote

USB Fast Charging Module

In stock

This is a buck module that is used to charge a phone via a USB port. The module supports Quick Charge 3.0 and accepts input from 12V to 24VDC. The module is based on the IC IP6505, which is a step-down converter with an integrated synchronous switch.

Add To Quote

USB FEMALE SOCKET HORIZONTAL

In stock

This is USB A Female Solder Connector (90 Degree). USB A 90 Degree | USB A Connector | USB A Connector Right Angle | USB 2.0 Female Connector | USB 2.0 4-Pin Female Socket Connector |

Add To Quote

USB LOGIC ANALYZER

In stock

If you don’t want to start with an expensive oscilloscope, this will be another good choice. With a total of eight digital channels, the voltage range is 0V ~ 5.5V, the voltage threshold is considered to be low below 1.5V, and 1.5V above is considered high. 24 m sampling rate, can automatically analyze UART, IIC, SPI, and many other standard protocols.

Add To Quote

USB to RS485 Converter

In stock

This is an industrial USB to RS485 converter with the original FT232RL and SP485EEN inside. It features embedded protection circuits such as lightning-proof, resettable fuse, ESD protection, and TVS diode, etc. It’s pretty small in size.

Add To Quote

USB TO RS485 Convertor ch340

In stock

DC 5V Industrial CH340 USB to RS485 Converter Communication Module TVS Transient Protection Communication Module

Add To Quote