Click to enlarge

Raspberry Pi Camera Module 3 Wide

After a long wait of almost 7 years, the Raspberry Pi released the camera-3 series, the successor to the Camera module 2 series. This newest addition to the Raspberry Pi mainstream camera lineup replaces the wildly successful Camera Module 2, which was introduced in April 2016.

The all-new Raspberry Pi Camera Module 3 Standard/Wide is a camera for Raspberry Pi computers. Featuring autofocus and a 12-megapixel sensor supported by Raspberry Pi’s Picamera2 Python library, Camera Module 3 gives you excellent image quality with precise control.

Add to wishlist
Compare
16 People watching this product now!

6000 +

Products

10:00am - 7pm

Working Hours

Genuine Products

Guaranteed

Description

  • Back-illuminated and stacked CMOS 12-megapixel image sensor (Sony IMX708)
  • High signal-to-noise ratio (SNR)
  • Built-in 2D Dynamic Defect Pixel Correction (DPC)
  • Phase Detection Autofocus (PDAF) for rapid autofocus
  • QBC Re-mosaic function
  • HDR mode (up to 3-megapixel output)
  • CSI-2 serial data output
  • 2-wire serial communication (supports I2C fast mode and fast-mode plus)
  •  2-wire serial control of focus mechanism
  • Improved low-light sensitivity.
  • High dynamic range (HDR) support.
Additional information
Pixel Size

1.4μm × 1.4μm
Horizontal/Vertical

4608 × 2592 pixels
Output

RAW10
Dimensions

25 × 24 × 11.5mm (12.4mm height for Wide variants)
Reviews (0)

Reviews

There are no reviews yet.

Be the first to review “Raspberry Pi Camera Module 3 Wide”

Your email address will not be published. Required fields are marked *

Recently Viewed Products